![]() Test each combination and see what does and doesn't work. Ideally they should be the same brand/model but the combination of X with your other component is the key one that you want to see whether it works on our.ģ - if all the hardware works then it points to Capture One as the problem. If they can't find a solution then you either live with the intermittent problem, do your tethering is a two-step process (software X for the connection, then read the files in Capture One), or look for an alternative to capture one that works with your hardware and gives you the RAW file editing capability you're looking for. Can I switch back to the manual mode after I set up Jobs?.Īfter a Job has been defined and the configuration has been uploaded to the Scan Station, only the Jobs screen will display on the Scan Station (the normal user interface will not display) Job settings are modified using the Scanner Administration Application.Ĭan I change the settings after I create Jobs?.The initial connection is made trough USB drivers loaded in the OS (Windows/Mac).You can access the manual mode after you remove all entries for Jobs in the configuration file (using the Scanner Administration Application). Or, you can also access the manual mode after inserting a USB drive that contains the configuration file (kss.xml). Do I need a computer to set up and use the Scan Station?.You do not need a computer to use the Scan Station however, you need a computer to create a configuration file, and to install and use the Scanner Administration application. Copying the configuration file (kss.xml) to a USB drive, and inserting the USB drive into the Scan Station.Using the Scanner Administration application from a Host (remote) computer.There are two methods for configuring the Scan Station: #KODAK SOFORTBILD STATION INSTALL# The configuration file can be exported from the Scanner Administration Application and must be named “kss.xml”. Does the Scan Station have USB and Ethernet ports?.This file must also be located at the root (top) level of the USB drive. Yes, the Scan Station 700 series has four USB ports and one Ethernet port. ![]() ![]() On the Host computer, open the Scanner Administration application.There are two ways to find this information: How can I determine the firmware version and Operating System (OS) of the Scan Station?.The USB ports are used for storing files to a thumb drive, accessing administrator settings, configuring the Scan Station, and connecting a USB Keyboard. How can I obtain professional services and support for the scanner?įor information on how to contact Alaris support, please visit Alaris Services and Support.Select the scanner from the grid and click the icon. How do I configure device settings (e.g., email server, active directory server, etc.)?įor information about configuring device settings, see Chapter 4 of the Administrator’s Guide.įor information about configuring the scan settings, see Chapter 5 of the Administrator’s Guide.įor information about creating jobs, see Chapter 8 of the Administrator’s Guide. ![]() Upload the configuration file to the Scan Station.Select Start the wizard or Run the Setup wizard at next restart.Insert the USB drive into the Scan Station.Copy the configuration file to the top level of a USB drive, and verify that the file name is do I reset the (Scan Station) settings to the factory defaults?. You may be asked by service personnel to provide log files to help diagnose an issue. Open the Scanner Administration application on the host computer.Using the Scanner Administration application: You can send log files as an attachment to an email. ![]()
0 Comments
Leave a Reply. |